DIY Address number wall planter

How cute is that? This is so simple to make and is a perfect project for your home.

DIY Address number wall planter

 How cute is that? This is so simple to make and is a perfect project for your home.

You will need:

-       plywood of 12mm -> backboard 40 X 35 cm

-       wood tray -> two side pieces of 25 X 10 cm, two side pieces of 12 X 10 cm and one bottom piece of 22.5X 12 cm

-       wood glue

-       nails ¾ ‘

-       hammer

-       sandpaper 120 grid

-       screws

-       power drill

-       ruler or tape measure

-       wood stain or any other paint color of your choice

-       pencil (for marking)

 

 

 

Start off by sanding all your wood pieces. Once your cuts are done glue and nail the tray (two sides (12 X 10 cm) and one of sides (25 X 10 cm) to the bottom piece). Before you nail it leave it to dry for a couple of minutes. Place the shelf on the marks where you want to place the tray and screw 2 points in the side of 25 X 10 cm attaching it to the backboard.  Then, glue the last piece of the long side to form the tray.

 

 

 

 Now you may stain it the color of your choice. Leave it to dry and with some heavy-duty glue or screws you attach the number(s) to the top corner.

Viola, ready to add some touch to your entry!....