IDEAL bending spring made of galvanized high-quality spring wire 2x2 mm. ('Buigveer')
For free-form bending of tubing without kinking
$22.99
Tax included
SKU
100021147
In stock
Limited amount left at Cay Hill
Description
A bending spring is used for making curves in plastic pipe, or for pipes made of soft copper. The tubes are bent by sliding a bending spring with the correct diameter in the tube, so that it can be bent without causing a kink.
A bending spring consists of a steel coil spring, with the windings tightly against each other.
For bending PVC installation pipes for electrical installations, inner bending springs of 5/8 and 3/4 inch (16 and 19 mm) are mainly used. A spring with a length of 0.8 - 1 m. is usually used for this purpose. An eye is located at one or both ends of the spring. You can attach a piece of rope or installation wire to one such eye, so that the spring can be pulled out of the tube after bending, even with long tubes.
Specifications
| Material | High quality spring wire 2 x2 mm |
|---|---|
| Length Metric (centimetre) | 80 |
| Usage | For tube bending 5/8 in. (16 mm) |
| Flame Retardant | No |
| Insulating | No |
| Suitable For High Voltage | No |
| Uv Resistant | No |
| Vde Tested | No |
| Insulated | No |
| Longitudinal Section | No |
Related Products
-
Tax includedItem nr: 100001279 -
Tax includedItem nr: 100018003 -
Tax includedItem nr: 100018004 -
Tax includedItem nr: 100000433Out of stock
Write Your Own Review